emerio SS-123248.1 Mode D'emploi page 8

Steam trigger
When the appliance is heated to the selected temperature, press and hold the steam trigger with a little
force, the steam will be sprayed from the soleplate continuously. When loosen the steam trigger, the
appliance can only be used for dry ironing without steam.
Shot of steam
This function can only be activated when the appliance is operated under MAX steam rate, the indicator of
MAX steam rate illuminates solidly and the temperature dial is set above the third setting.
Quickly press the steam trigger twice to produce the shot of steam, and the indicator of MAX steam rate
will blink. After the blink is finished, wait for approx. 10 seconds to proceed the second shot of steam. ECO
steam rate has no such function.
Water spray button
When you need to activate the water spray function, press and hold the water spray button with a little
force, the spray nozzle will spray water and wet the clothes that need to be ironed, and then release the
water spray button to stop.
Clean indicator
The appliance needs to be cleaned when the clean indicator illuminates solidly. And the clean indicator will
blink when the appliance is being cleaned.
Clean button
1. The appliance must be cleaned when the clean indicator illuminates solidly. Before perform cleaning,
prepare a container with a capacity of more than 300ml for collecting the waste water, then put the
appliance on the container and place the container steadily. Press and hold the clean button for approx.
2 seconds. When the buzzer sounds, the operator should remove from the appliance to avoid being
burnt by high-temperature steam during the cleaning process. The appliance enters into the cleaning
mode and the clean indicator blinks. After about 2 minutes, the cleaning is completed and the
appliance returns to the working condition.
2. When the clean indicator does not illuminate and the user needs to perform cleaning, press and hold
the clean button for approx. 5 seconds. When the buzzer sounds, the operator should remove from the
appliance to avoid being burnt by high-temperature steam during the cleaning process. The appliance
enters into the cleaning mode and the clean indicator blinks. After about 2 minutes, the cleaning is
completed and the appliance returns to the working condition.
Container
- 7 -