ROSIERES TRIPLE 10G Notice D'emploi Et D'installation page 29

Masquer les pouces Voir aussi pour TRIPLE 10G:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

REMEMBER! the oven and the dishwasher cannot be used in the same time.
Should the dishwasher fail to operate, before contacting the Service Centre, make the following checks:
FAULT
1 - Machine completely dead
2 - Machine does not drawwater
3 - Machine does not discharge water
4 - Machine discharges water continuously
5 - Spray arm is not heard to rotate
6 - On electronic appliance without a
display: "Eco" indicator light and indicator
light "No 1", with audible signal
7 - Load of dishes is only
partially washed
8 - Presence of white spots on dishes
9 - Noise during wash
10 - The dishes are not
completely dry
TROUBLESHOOTING
CAUSE
Plug is not connected correctly
O/I button has not been pressed
No electricity
Door is open
See causes for No 1
Water tap is turned off
Programme selector is not at correct position
The inlet hose is bent
The inlet hose filter is blocked
Filter is dirty
Outlet hose is kinked
The outlet hose extension is not correctly connected
The outlet connection on the wall is pointing
downwards not upwards
Position of outlet hose is too low
Excessive amount of detergent
Item prevents arm from rotating
Plate and cup filter very dirty
Water inlet tap turned off
See causes for No 5
Bottom of saucepans have not been washed well
Edge of saucepans have not been washed well
Spray arm is blocked
The dishes have not been properly loaded
The end of the outlet hose is in thewater
The incorrect amount of detergent has been
measured out; the detergent is old and hard
The tap of the salt dispenser is not closed very well
The wash programme is not thorough enough
Water is too hard
The dishes knock against one another
The revolving arm knock against the dishes
Inadequate air flow
28 GB
REMEDY
Connect electric plug
Press button
Check the electricity supply
Close door
Check
Turn water tap on
Turn programme selector to correct position
Eliminate the bends in the hose
Clean the filter at the end of the hose
Clean filter
Straighten outlet hose
Follow the instructions forconnecting the outlet
hose carefully
Call a qualified technician
Lift outlet hose to at least 40 cm
above floor level
Reduce amount of detergent
Check
Clean plate and cup filter
Switch off the appliance - Turn on the
tap - Re-set the cycle
Check
Burnt on food remains must be soaked before
putting pans indishwasher
Reposition saucepans
Remove spray arm by unscrewing ring nut
clockwise and wash under running water
Do not place the dishes too closely together
The end of the outlet hose must not come into
contact with the outflow water
Increase the measure according to how dirty
the dishes are and change detergent
Tighten it fully.
Choose a more vigorous programme
Check salt and rinse aid level and regulate
amount. Should the fault persist, contact Service
Centre
Load dishes better onto the basket
Load dishes better
Leave the dishwasher door ajar at
the end of wash program to allow dishes to dry
naturally

Publicité

Table des Matières
loading

Table des Matières