ROSIERES TRIPLE 10G Notice D'emploi Et D'installation page 26

Regulating the water softener with electronic programmer
The water softener can treat water with a hardness level of up to 60 Fh (French grading) or 33 Dh (German grading) through 5 settings.
The settings are listed in the panel below:
Level
0
1
2
3
4
The softener unit is set in the factory at level 3 (indicator light N.3) as this is suitable for the majority of users.
Regulate the setting of your water softener unit according to the degree of hardness of your water as follows: Open the door, press
On / Off button, within 2 minutes press and keep pressed for at least 10 seconds the Programme Selection button; the first three LEDs
on the left turn on for 3 seconds.
The LED associated with the set water softener starts flashing; successive button pushing will set the water hardness levels (see table).
Information for the test laboratories General programme comparison
Ref. EN 50242 standards:
1) Normal load
2) Shine setting: "4"
3) Amount of detergent: 18gr. for wash
Water hardness Water hardness
fH (French) dH (German)
0-8
9-20
21-30
31-40
41-60
LEDs
WASHING PROGRAMME
USE
Use of regenerating
4
5-11
12-17
18-22
23-33
PROGRAMME SELECTION BUTTON
25 GB
Water softener
salt setting
no Indicator light N.1
yes Indicator light N.1
yes Indicator light N. 2
yes Indicator light N. 3
yes Indicator light N. 4