Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
3. At a 45° angle, align door hinges with slots in the lower
front of the oven cavity. Slowly insert door, making
sure you maintain the 45° angle. You will know the
door is engaged in the slot when you feel a slight drop.
4. Lower the oven door to the fully open position. If the oven
door does not open to a full 90°, repeat steps 1 through 3.
5. Locate the oven door hinge locks in the corners of the oven
door, and rotate the hinge locks toward the oven cavity to
the locked position.
See Step 3 (illustration A) in the "Remove Oven Door(s)"
section for proper locked position.
6. Close the oven door.
7. When the hinges are properly installed and the door closed,
there should be an even gap between the door and the
control panel. If one side of the oven door is hanging lower
than the other, the hinge on that side is not properly installed.
8
Positioning Oven Feet for Multiple
Cabinet Cutout Heights
Single Ovens
The positioning of the oven feet allow a single oven to be
installed in a cutout height between 26¹
and 74.8 cm). Refer to the following instructions to position the
feet for the size of your cabinet cutout.
Cutout Height Is Between 27
(70.2 cm and 72.7 cm)
The oven feet do not need to be changed. They are positioned
correctly as received.
Go to the "Make Electrical Connection" section.
Cutout Height Is Between 26
(68.4 cm and 70.3 cm)
1. Using 2 or more people, place the oven on its back on a
covered surface.
⁄
" and 29
⁄
" (68.4 cm
5
7
16
16
⁄
" and 28
⁄
"
5
5
8
8
/
" and 27¹¹⁄
"
15
16
16
Publicité
Table des Matières
