Environmental Specifications - TDK-Lambda CUS400M Mode D'emploi

Masquer les pouces

Table des Matières

Les langues disponibles

CUS400M Handbook

Special Instructions for medical applications of the following standards:

CSA-C22.2 No. 601.1-M90

IEC/EN/UL 60601-1 3

ANSI/AAMI ES 60601-1

CSA 22.2 No 60601-1

These products are designed for continuous operation within an overall enclosure, and must be

mounted such that access to the mains terminals is restricted. See the appropriate standard listed

above.

These products are NOT suitable for use in the presence of flammable anesthetic mixtures with air or

with oxygen, or with nitrous oxide.

For IEC/EN 60601-1 3

provide reinforced insulation between input and outputs of 2 MOPPs. 1 MOPP from input to

Earth/chassis/customer fixing point and 1 MOPP from output to Earth/chassis/customer fixing point.

These products are suitable for B and BF type medical equipment.

These products are NOT protected against the ingress of water.

All outputs have basic spacing to earth rated for mains at 250Vac, and due consideration must be

given to this in the end product design.

These products have SELV or ES1 outputs.

Reference should be made to local regulations concerning the disposal of these products at the end of

their useful life.

Where any part of this product is made accessible to the operator in the end use equipment, the

operator must not touch this part and the patient at the same time.

The chassis/cover/customer fixing points when fitted to the CUS400M in a Class II configuration has

(Basic/Supplementary) insulation to Primary and (Basic/Supplementary) insulation to Secondary.

For Single fuse (/E option) the end equipment manufacturer must use a polarised input connector.