Krüger & Matz KM0650 Mode D'emploi page 18

• Previous: press and hold for 2 seconds ‚Volume down' button to go to
previous track.
• Next: press and hold for 2 seconds ‚Volume up' to go to next track.
• Answer call: press multifunction button to answer the incoming call.
• End call: short press multifunction button.
• Reject call: press and hold the ‚Volume up' button to reject a call.
• Transfer call: during a phone call, press and hold ‚Volume up' button,
call switches to mobile phone. Press and hold ‚Volume up' button again,
call switches back to headphones.
• Last number redial: in standby status, press headphone multifunction
button twice to redial the last number. In case of multipoint connection
with two phones, the redial will be performed from the phone which
was connected first.
• Battery Capacity status: when headphone is connected to iOS
devices, iOS devices shows the headphone battery power status in the
upper right corner.
Operation
Power on
Power off
Pairing
Standby
Incoming call
Low battery
Charging
Active noise reduction function (ANC)
When there is too much noise in surroundings, switch the ANC key to
"ON" (the ANC LED will be on).
Note: phone call function cannot be used in this mode.
Sound quality with apt-X® code
Featuring the apt-X code, the headsets can connect wirelessly to
18
LED Status
Blue LED flashes 2 times
Red LED flashes 2 times
Red LED & Blue LED flashes alternately
Blue LED flashes 3 times every 5 seconds
Blue LED blinks
Red LED flashes 2 times every 2 seconds
Red LED keep lighting during charging
Blue LED keep lighting charging finished
Owner's manual