Spektrum AR6255 Guide De L'utilisateur page 5

EN
Note: If the antenna is to be mounted internally (in the front of a 2.4GHz fuse), the
coaxial can be taped into position. Be sure the 31mm tip is located at least
2 inches from any significant carbon structure.
Step 5. Plugging in the Servo Leads
Plug the servo leads into the appropriate servo ports in the receiver, noting the
polarity of the servo connector. Consult your radio's manual for specific details as to
which servo plugs into which servo port channel.
Step 6. Binding the Receiver
The AR6255 must be bound to the transmitter before it will operate. Binding is the
process of teaching the receiver the specific code of the transmitter so it will only
connect to that specific transmitter.
1. To bind an AR6255 to a DSM2 transmitter, insert the bind plug in the BIND/
DATA port on the receiver.
2. Power the receiver through any other port. Note that the orange LED on the
receiver should be flashing, indicating that the receiver is in bind mode and
ready to be bound to the transmitter.
3. Move the sticks and switches on the transmitter to the desired failsafe positions
for the throttle, elevator and aileron channels.