Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
The device programmation and the panel configuration are made by
outputs as:
• If
is powered with the non-rechargeable battery (KSI7207580.000) the outputs will be managed
imago
as below, regardless the programmed configuration
•
Alarm output: monastable with the same ON time as programmed on the Panel (default: 3 min.)
•
Power LED output: monostable with fixed 20 sec. ON time
•
Aux LED output: monostable with fixed 20 sec. ON time; this function is designed to save battery
• If
wireless is powered with external 12Vdc supply and rechargeable acid lead battery, it will
imago
manage the outputs as programmed
During the programming phase, every time the
acknowledged the red LED on the wireless PCN module will blink.
The procedure to power up the imago requires to respect at least one of the following steps:
• Connect the batteries to their connector
• Connect the power supply poles + and - (12Vcc) to their clamps
battery to the respective cables with faston
If wiring is correct,
imago
POWERING UP
13
will show a single flash by the power LED and a short BEEP by the buzzer.
FUNCTIONS
sends a tamper signal to the panel and it is
imago
and place it on its base
OR
after been placed on its base
21
SW. The siren manages the
basis
as shown in figure
10
and the acid lead backup
14
as shown in figure
10
EN
11
Publicité
Table des Matières
