Troubleshooting
If the appliance does not function properly, please check the below table for the solution. If you are still unable
to solve the problem, please contact the supplier/service provider.
Problems
The appliance is connected
to the power supply but does
not function.
Temperature inside the ap-
pliance is too warm.
Moisture forms on the in-
side appliance walls.
Too much Vibration.
The door will not close prop-
erly.
Possible causes
1. Power plug is not connected
properly to the electrical power.
2. The circuit breaker tripped or a
blown fuse.
1. Temperature is set too warm.
2. Door is kept open too long.
3. The door gasket does not seal
properly.
1. Door is kept on for too long.
1. The appliance is not placed lev-
el.
1. The Wine Cooler is not placed
level.
2. The door was reversed and not
properly installed.
3. The shelves are out of position.
Possible solutions
1. Check again to make sure it is
connected properly.
2. Contact the supplier.
1. Turn to a cooler setting.
2. Open door less.
3. Check to make sure the door gas-
ket seal properly.
1. Open the door less.
1. Check the level and adjust the feet
until the wine cooler is level. (Mi-
nor vibration is normal)
1. Check the level and adjust the feet
until the wine cooler is level.
2. Contact the supplier
3. Check and put the shelves on
right position.
EN
9