Table des Matières
Publicité
Manual Brew Monk - EN
ASSEMBLY INSTRUCTIONS
Install the thermowell. Make sure the nut is screwed on properly. Install the black rubber stopper. Insert
the thermometer.
The bottom of the fermenter has 2 holes. Originally, the top hole is intended for mounting the bottling
valve. Hold the seal on the provided recess and place the tap against it. Wrap the tri clamp fitting around
it and tighten. Tip: insert the rotating arm into the valve inlet as shown, the racking arm direction can be
adjusted by rotating the ball-valve during fermentation.
The bottom hole in the fermenter is for mounting the large butterfly valve. You can choose to mount the
elbow first. Proceed in the same way as with the above tap.
Mount the legs at the desired height with the leg butterfly nuts and screws.
9
Publicité
Table des Matières
