Device Description; Initial Use - Beurer FC 49 Mode D'emploi

IMPORTANT
Only specialist personnel may perform repairs on electrical devices. Improper repairs may subject
users to considerable danger. In the event of a fault or damage, have the device repaired by a certi-
fied specialist workshop.

6. Device description

1. Fine cleansing area
2. Precise cleansing area
3. ON/OFF button
4. Intensity control - / +

7. Initial use

Charge the device for at least 2 hours before initial operation. To do this, proceed as follows:
1. Insert the mains cable into the charging socket on the rear of the facial brush.
2. Insert the USB plug to the mains adapter and connect this with the mains socket.
3. Whilst charging, the white LED light in the transparent base of the facial brush will flash.
4. When the battery is fully charged, the LED light will remain on.
Note
When the battery is low the device will flash 9x and then turn itself off.
IMPORTANT
Do not use the device while it is charging!
1
2
3
4
7
5. Coarse cleansing area/massage area
6. LED light
7. Charging socket with waterproof seal
18
5
6