How To Use; Functions - Steba LB 6 Mode D'emploi

HUM /
SPEED

FUNCTIONS

∙ Ultrasonic atomization technology with either cool or warm mist. (The temperature
of warm mist is between 40°C to 50°C)
∙ Water softening function: To soften hardness of water in order to prolong the
useful life of the product.
∙ Water tank with an expandable handle that is convenient to use.
∙ There are three different modes for mist control.
∙ High humidifying capacity:300ml/h;
∙ Middle humidifying capacity:200ml/h;
14
∙ Low humidifying capacity:100ml/h.
∙ Integrated with two rotating nozzle that allows users to adjust the direction of the
mist.
∙ The tank is in blue and with lighting effects. The tank would alight once the humi-
difier has been turned on and would sparkle when there is lack of water.
∙ Humidity display: show the indoor humidity in the area.
∙ Automatic humidity control: User can set the humidity in the room according to
their will (from 30% RH – 70%RH). When the indoor temperature reaches the set-
ting, there will be an automatic cut-off.
∙ Emitting mist continuously: The humidifier could be established for emitting mist
continuously while neglecting the humidity in the area.
∙ Timer: Automatic shut down function, user can set the timer before they go to
sleep or before leaving the area. (Available from 1 hour to 12 hours)
∙ Shut down protection when water-short: The unit will alarm if there is a lack of
water. This helps to prevent danger due to the lack of water and protect the humi-
difier.
∙ Touch sensor: Control panel is made of a top grade capacitance sensor touch switch.
∙ An outlet at the bottom of the humidifier, for easy cleaning and the disposal of
water remaining in the gutter.

HOW TO USE

Preparation before turning on the humidifier:
Preparation for the filter
1. Take the tank out, and then the filter.
2. For the first time of use, rinsed the filter until the dependencies on the surfaces of
the yellow particles are gone.
Note: This filter is an additional item. The operation of the humidifier would not be
affected without it.
Adding water to the tank
1. Put the humidifier on a horizontal surface. Take the tank out from the humidifier.
Note: Do not add water to the GUTTER directly.
2. Turn the tank upside down. Unscrew the cover anti-clockwise. Fill the tank with
clean tap water or distilled water within 5°C to 40°C until water reaches the stated
line.
3. Screw the cover on clockwise. Dry water on the outer part of the tank.
4. Put the filter and the tank back. There will be "gurgling" sounds and air bubbles
would appear once the tank is placed correctly into the humidifier. Water in the tank
would then pass through the filter to be purified, sterilized and softened, which
would take 2 to 5 minutes. Once there are no more air bubbles, this indicates that
there is sufficient water in the gutter and is now ready for the humidifier to generate
mist.
Waterfilter
15