Table des Matières
Publicité
PSTx
12.30 Fieldbus AI 9
12.31 Fieldbus AI 10
19.04 Fieldbus failure op.
4.2 Danfoss - Vacon
FC 200
4–10 Motor speed direction
8-01 Control site
8-02 Control source
8-30 Protocol
8-31 Address
8-32 Baud rate
8-33 Parity / Stop bits
8-43 PCD Read
• [02] Configuration
• [03] Configuration
• [04] Configuration
• [05] Configuration
• [06] Configuration
• [07] Configuration
• [08] Configuration
MCD 200 - Avec extension RS 485 en option.
Ajoutez un câble volant entre les bornes A1 et N2.
MCD 500 - Avec extension RS 485 en option.
Ajoutez des câbles volants entre les bornes 17–18 et 18–25. Utilisez au maximum 19200 Baud.
MCD 200, MCD 500
Protocol
Slave ID
Baud rate
Parity
Soft starter
Power factor
Not used
Consider change to "Stop-automatic" for avoiding manual trip
reset in case of intermittent corrupted Modbus messages
Variable speed drive
[2] Both directions
[2] Ctrl. word only
[1] FC port
[2] Modbus RTU
Unique slave ID corresponding to EC 531 setting
Same as EC 531
Same as EC 531
[1612] Motor voltage
[1613] Frequency
[1616] Torque [Nm]
[1617] Speed [RPM]
[1622] Torque %
[1610] Power [kW]
[1614] Motor current
Soft starter
Modbus RTU
Unique slave ID corresponding to EC 531 setting
Same as EC 531. Max 19200 baud.
Same as EC 531
13
FR
Publicité
Table des Matières
