HEINE Headlights Mode D'emploi page 11

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 15
Operation
HEINE
ML4 LED
®
To set up the HEINE
ML4 LED with HEINE
mPack or HEINE
EN50, connect the
®
®
®
short cord from the brightness control with the connecting cord mPack UNPLUGGED/
Cinch and fix this to the back part of the headband (Fig. 8). Connect the instrument to
the Cinch-socket of the mPack or EN 50. The rheostat (1) (Fig. 6) is used to adjust the
brightness and to turn the device on and off.
Fig. 8
To use the ML4 LED with the HEINE
mPack UNPLUGGED first remove the rear cover of
®
the headband (Fig. 9).
Fig. 9
Then attach the mPack UNPLUGGED to the rear of the headband. To do so, hold the
headband in your left hand and push the mPack UNPLUGGED to the left, until it clicks
into place (Fig.10).
Fig. 10
Selecting viewing angle and field of view (Fig. 4)
Without HEINE
S-Guard
®
• After loosening the locking screw (4), the light head can inclined and the angle of the
light direction can be adjusted.
• After adjustment, re-tighten the screw (4).
11/76
med 0714
2016-06-30

Publicité

Table des Matières
loading

Table des Matières