System Settings; Illumination Settings - Pioneer DEH-1800UB Mode D'emploi

Menu Item
LOUDNESS
[OFF], [LOW], [MID], [HI]
SUB.W*2
[NOR], [REV], [OFF]
SUB.W CTRL*2*3
Cut-off frequency: [50HZ],
[63HZ], [80HZ], [100HZ], [125HZ],
[160HZ], [200HZ]
Output level: [–24] to [+6]
Slope level: [–12], [–24]
BASS BOOST
[0] to [+6]
HPF SETTING
Cut-off frequency: [OFF], [50HZ],
[63HZ], [80HZ], [100HZ], [125HZ],
[160HZ], [200HZ]
Slope level: [–12], [–24]
SLA
[+4] to [–4]
*1 Not available when [SUB.W/SUB.W] is selected in [SP-P/O MODE] in the INITIAL settings (page 5).
*2 Not available when [REAR/REAR] is selected in [SP-P/O MODE] in the INITIAL settings (page 5).
*3 Not available when [OFF] is selected in [SUB.W].

SYSTEM settings

You can also access to these menus when the unit is turned off.
Menu Item
LANGUAGE
[ENG](English), [РУС](Russian),
[TUR](Turkish)
CLOCK SET
12H/24H
[12H], [24H]
Description
Compensate for clear sound at low volume.
Select the subwoofer phase.
Only frequencies lower than those in the
selected range are output from the subwoofer.
Select the bass boost level.
Only frequencies higher than the high-pass filter
(HPF) cutoff are output from the speakers.
Adjust the volume level for each source except
FM.
Description
Select the language to display the text
information from a compressed audio file.
Set the clock (page 4).
Select the time notation.
Menu Item
AUTO PI
[ON], [OFF]
AUX
[ON], [OFF]
USB AUTO
[ON], [OFF]
MUTE MODE (Not available for DEH-1800UBA)
[MUTE], [20dB ATT], [10dB ATT]
PW SAVE*
[ON], [OFF]
ANDROID WIRED
[MEMORY], [APP CONTROL]
P.APP AUTO ON
[ON], [OFF]
* [PW SAVE] is canceled if the vehicle battery is disconnected and will need to be turned back on once
the battery is reconnected. When [PW SAVE] is off, depending on connection methods, the unit may
continue to draw power from the battery if your vehicle's ignition does not have an ACC (accessory)
position.

ILLUMINATION settings

Menu Item
DIM SETTING
[SYNC CLOCK], [MANUAL]
Description
Search for a different station with the same
programming, even if using a preset station.
Set to [ON] when using an auxiliary device
connected to the unit.
Select [ON] to automatically switch to [USB]
source when a USB device is connected to the
unit.
Select [OFF] when a USB device is being
connected to the unit just for charging.
Mute or attenuate sound automatically when a
signal from equipment with a mute function is
received.
Reduce the battery power consumption.
Turning on the source is the only operation
allowed when this function is on.
Select the appropriate connection method for an
Android device.
Select [ON] to automatically launch the car remote
application when an Android device is connected
to the unit via AOA. (Not available when
[MEMORY] is selected in [ANDROID WIRED].)
Description
Change the display brightness.
9
En