Low Battery Signal - Quick PW4 Mode D'installation Et D'emploi

OPERATION - MAINTENANCE - TECHNICAL DATA
Disabling the transmitter
The disabling of a transmitter that is in operational status can take place automatically and manually.
Automatic mode: if within 3 minutes no key has been pressed, the transmitter is disabled and the transmission LED shuts off.
Manual mode: the transmitter can also be disabled manually, without waiting 3 minutes. Keep both
PW4 model and 1
2
that the transmitter has been disabled.

Low battery signal

It is recommended to replace the battery within a short period of time if the transmission LED is red during operation. The
residual autonomy time depends on the quality of the battery used.
BATTERY REPLACEMENT
WARNING: danger of explosion if battery is replaced with an other of incorrect type.
WARNING: before operating on the transmitter, make sure that the RRC radio receiver is not powered. Accidentally press-
ing a key may activate the corresponding device and create a dangerous situation.
• Remove the transmitter base by unscrewing the four screws using a Phillips
screwdriver.
• Remove the battery from the battery holder sliding it outwards without using
metal tools.
• Insert the new battery (of the type indicate in the technical characteristics)
paying attention to polarity of the positive pole (+) as shown on the metal
battery holder.
• Close the transmitter base, checking that it sits correctly in the gasket groove,
located on the front of the transmitter, in order to restore the seal.
• Tighten the four screws.
WARNING: once closed, verify that the transmitter is operating
correctly.
At the end of its useful life, the battery contained in the product must be
F
disposed of separately from other separated urban waste.
Dispose of the battery in accordance with the provisions of local law.
MAINTENANCE
The RRC Thruster pocket radio transmitter does not require particular maintenance. Use a soft cloth moistened with water when
cleaning it. Do not use chemical or abrasive products.
TECHNICAL DATA
MODELS
INPUT CHARACTERISTICS
Power supply
Absorption during transmission
CHARACTERISTICS OF THE TRANSMITTER
Number of keys
Carrier frequency
Modulation
Compliant with directive
GENERAL
Operating temperature
Dimensions (W x H x D)
Weight (including the battery)
QUICK ® RESERVES THE RIGHT TO MODIFY THE TECHNICAL CHARACTERISTICS OF THE EQUIPMENT AND THE CONTENTS OF THIS MANUAL WITHOUT PRIOR NOTICE.
RRC PW4-PT4 - REV003A
keys for the PT4 model. The orange transmission LED will flash regularly and then shut off to signal
BATTERY
HOLDER
PW4
CR2450 3V lithium battery
13 mA
4
434.420 Mhz
FSK
2014/53/EU (RED)
from -15°C to +70°C
60 x 47 x 23 mm
34 g
EN
keys pressed for the
SCREWS
TRANSMITTER
BASE
TRANSMITTER
FRONT
CR2450 3V
LITHIUM BATTERY
PT4
4
11