Use; Cleaning; Disposal; Technical Data - Beurer MG 70 Mode D'emploi

6. Use

Purpose: The appliance is used solely for massaging the human body.
Decide whether you wish to use the massage device with its handle attached or without a handle, using
a hand strap. To remove the handle, press hard on the two retention buttons on either side of the handle
and pull the handle off the massage head. Insert the plug-in cover into the back of the massage head.
Put your hand under the hand strap. Using the Velcro fastener, adjust the length of the hand strap so that
you can hold the massage head in your hand and guide it safely.
If you wish to attach the handle again, first pull off the plug-in cover and reattach the handle until it is
heard to engage. The power cable emerges from beneath the handle retainer.
You can massage with or without the massage attachment. Simply choose the massage attachment that
you prefer. With M+H intrared heat treatment, any massage attachments will prevent the heat supply
of the infrared source. You should therefore only operate the device on ‚M' if a massage attachment is
fitted.
Make sure that the device is switched off before inserting the power cable. Switch on the device by
setting the sliding switch to
‚M' (‚Massage only') or
‚M+H' (‚Massage with infrared heat').
Set the required massage speed using the control. Place the device on the part of the body which you
wish to massage. You can stand up, sit down or lie down and you can either massage yourself or mas-
sage somebody else. Massage intensity can be varied by exerting more or less pressure on the massage
device. Never massage a specific part of the body for longer than 3 minutes without changing to another
area of the body. After using for a maximum of 20 minutes, switch off the device again, disconnect the
plug and let it cool down. Store the device in a dry place.

7. Cleaning

To clean the unplugged device after it has cooled down, wipe with a slightly damp cloth. You can use
a mild cleaning agent. However, ensure that water never gets inside the device. Do not use the device
again until it is completely dry.

8. Disposal

For environmental reasons, do not dispose of the device in the household waste at the end of its
useful life. Dispose of the unit at a suitable local collection or recycling point. Dispose of the de-
vice in accordance with EC Directive – WEEE (Waste Electrical and Electronic Equipment). If you
have any questions, please contact the local authorities responsible for waste disposal.

9. Technical data

Disposal 220-240 V~, 50/60 Hz, 22 W

10. Warranty / Service

Beurer GmbH, Söflinger Straße 218, 89077 Ulm, Germany (hereinafter referred to as "Beurer") provides a
warranty for this product, subject to the requirements below and to the extent described as follows.
The warranty conditions below shall not affect the seller's statutory warranty obliga-
tions which ensue from the sales agreement with the buyer.
The warranty shall apply without prejudice to any mandatory statutory provisions on
liability.
Beurer guarantees the perfect functionality and completeness of this product.
The worldwide warranty period is 3 years, commencing from the purchase of the new, unused product
from the seller.
11