Wide-Angle Diffuser - Metz MECABLITZ 50 AF-1 digital Mode D'emploi

Masquer les pouces Voir aussi pour MECABLITZ 50 AF-1 digital:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 30
Tip:
If you do not necessarily need the full guide number and maximum flash range
of the flash unit, you can leave the zoom reflector at the position for the shortest
focal length of the zoom lens. This will provide full light coverage of the picture
and eliminate the need to continually adjust it to the focal length of the lens.
Example:
You use a zoom lens with a focal length range of 35 mm to 105 mm. In this
case, you set the position of the main reflector of the flash unit to 35 mm.
Resetting to auto-zoom
• Touch the shutter release to begin a data transfer
between the flash unit and the camera.
• Press the button combination „Select" until
„M.Zoom" appears flashing next to the
zoom position (mm).
• Press the button + until the 105 mm position has
been exceeded. The flashing display „M.Zoom"
Zoom
8,7
50
m
mm
Zoom
92
changes to „Zoom" (= auto-zoom mode)
and the zoom position of the main reflector
is automatically adjusted to the lens focal
length. The setting takes effect immediately.
After about 5 seconds the display stops flas-
hing and the setting is saved automatically.
The return from manual zoom mode to
auto-zoom mode also occurs if the
flash unit is switched on again with the
main switch
.

Wide-angle diffuser

With the wide angle diffuser
, focal lengths of
12 mm or more can be illuminated (35 mm format).
Pull the wide-angle diffuser
out from the main
reflector as far as it will go, and then release it. The
wide-angle diffuser
automatically folds down-
wards. The main reflector
automatically moves to
the required position. The distance readings and the zoom value are corrected
to 12 mm on the display panel.
The automatic adjustment of the motor-zoom main reflector
activated if the wide-angle diffuser is in use.
To insert the wide-angle diffuser
all the way in.
Mecabounce 58-90
If the Mecabounce 58-90 (optional accessories, see 17) is fitted to the main
reflector
of the flash unit, the main reflector is automatically guided to the
position required. The distance data and zoom factor are corrected to 16 mm.
The automatic adjustment of the motor-zoom main reflector
activated if the Mecabounce is in use.
The simultaneous use of the wide-angle diffuser and the Mecabounce is
not possible.
, turn it upwards 90° and push it
is not
is not

Publicité

Table des Matières
loading

Table des Matières