On/Off Switching; Normal Operation: Moving Table Up/Down; Saving The Position; Retrieving The Saved Position - Häfele 633.52.330 Instructions D'utilisation

12

5.1 On/off switching

To switch on, hold down the "S" key (B) until the height appears.
If there is no activity, the operating unit automatically switches to standby mode after
approx. 10 seconds. The display is switched off.
If the operating unit is activated again, a bar appears in the middle of the display in-
dicating that the device is blocked.
To unblock the device, see chapter 5.7 Unblocking the display.

5.2 Normal operation: Moving table up/down

• Press button "" (D) or button "" (C) and hold it down until the required
position is reached. The number that lights up is the height in centimetres
(see Figure 1 in the picture section).

5.3 Saving the position

Positions can be saved on buttons 1, 2 or 3.
• Move table to required height.
• Press button "S" (B). "S" symbol starts to flash for 3 seconds on the display.
• Press button on which position should be saved (button 1, 2 or 3). The height
has been saved.
• "S1" (S2, S3) appears in the display for approx. 1 second (see Figure 2 in picture
section).

5.4 Retrieving the saved position

• Press button 1, 2 or 3 and hold it down until the required position is reached.
• The current height appears on the display during movement (see Figure 3 in
picture section).

5.5 Individually adapting the control unit

The control unit is displaying 68 cm as the preset height. Because of different table
top thicknesses, for example, it may be necessary to reset the height.
• Press buttons "S" and " " or "" simultaneously
• Display of current table height.
• Release button (See Figure 4 in picture section).

5.6 Blocking the control unit

The display has a "zero function", i.e. if the control unit is not used for 10 seconds,
it goes into standby mode and is blocked.
• Display blocked: a bar in the middle of the display illuminates (see Figure 6 in
picture section).

5.7 Unblocking the display

• Press button "S" (B) for five seconds until a number can be seen on the control
element.
• Press button 1, 2 or 3 and hold it down until the required position is reached
(see Figure 7 in picture section).