BH HIPOWER H720BM Instructions De Montage Et Utilisation page 8

5. FITTING THE BOTTLE HOLDER.-
Release the screws (93) on the handlebar (17),
position the bottle holder and adaptor (92) lower the
cover(61) and secure it by using the screws (93)
removed previously.
6. INSTRUCTIONS FOR FITTING THE
SADDLE.-
Take the horizontal tube for the saddle (23) and attach
the saddle (74) to it, Fig.6, tighten the nuts (Z).
VERTICAL ADJUSTMENT.
In order to raise or lower the saddle post, first loosen
off the control knob (91) on the saddle post a little by
turning it in an anticlockwise direction, pull the control
knob back and without releasing it, move the saddle
post up or down, Fig.6. When it is at the right height
release the knob and it will lock into a hole on the
saddle post. Tighten it up by turning the control knob
(91) in a clockwise direction.
HORIZONTAL ADJUSTMENT.
To adjust the saddle's horizontal position, loosen the
control knob on the saddle's horizontal bar and move
the saddle, along with the bar, into the desired
position, then tighten the control knob securely, Fig.6.
TILTING THE SADDLE.
The saddle can be tilted backward or forward. Loosen
off nut (Z) shown in Fig.6, located under the saddle,
tilt the saddle into the desired position and then
retighten the nut securely.
Do not adjust the tilt of the saddle while you are
still sitting on it.
7. FITTING THE MONITOR.-
Fit the handlebar (29) onto the handlebar stem (17)
with the screws (66) and washers (64) and (65) Fig. 7.
Bring the monitor (72) to the handlebar stem (17)
Fig.8, connect the terminals coming out of the
handlebar stem (17) and the monitor (72).
Insert the monitor (72) onto the handlebar stem (17),
as shown in Fig.8, making sure not to pinch any of the
cables.
Fit the bolts (73), making sure that the handlebar is
aligned correctly, securely tighten all of the bolts on the
handlebar stem including the bolts at the base which
were left hand tight in point 4.
Take the monitor covers, Fig.8. Now use the screws
(62) to attach them to the post and the cover (61) with
screws(89).
LEVELLING.-
Once the unit has been placed into its final position,
make sure that it sits flat on the floor and that it is
level. This is achieved by screwing the adjustable foot
(34) up or down, Fig.9.
MOVEMENT & STORAGE.-
The unit is equipped with wheels (38) to make it
easier to move about. The two wheels at the front of
the unit make it easier to place the unit in any chosen
position, as shown in the Fig.10. Store it in a dry
place, preferably
temperature.
MAINS CONNECTION.-
Insert the jack (m) on the transformer (75) into the
connection hole on the main body (1) (bottom, rear of
the machine) and then plug the transformer into a 220
V mains supply, Fig.11.
Do not hesitate to get touch with the Technical
Assistance Service if you have any queries by
phoning customer services (see last page in manual).
BH RESERVES THE RIGHT TO MODIFY THE
SPECIFICATIONS OF ITS PRODUCTS WITHOUT
PRIOR NOTICE
8
MOD. H720BM
not subject to changes in