Maintenance - Husqvarna SR600-2 Manuel D'utilisation

5. Make sure that the handle and safety features are in
good working order. Never use a product that lacks a
part or has been modified outside its specifications.
To use the attachment
The sweeper works best when the rubber lamellas can
glide or 'stroke' the working surface. New or replaced
brush drums tend to fasten or drag on hard surfaces and
shall therefore be 'run in' thoroughly before use. This
can be done easily by operating the product at full
throttle/speed for 3-5 minutes in loose gravel or similar
grinding material. After being run in, the sweeper will be
able to move large amounts of material from snow or
puddles to heavier objects such as gravel or wood chips.
In time, you will learn how the sweeper works but you
must observe safety precautions from the very
beginning.
1. Run the sweeper at full (or nearly full) throttle/speed
with the rubber lamellas resting on the surface.
Note: It is both tiresome and unnecessary to lift up or
hold the rubber lamellas above the surface while
working.
2. When clearing narrow surfaces such as paths, the
product can be used so that it throws materials
straight in front of you. If you want to work on wider
surfaces, you may need to work at an angle so that
strands form on one side. Strands comprising light
materials can be collected into one row or pile for
later removal while hard or more bulky materials may
need collecting in several strands.
Introduction
Below you will find some general maintenance
instructions. If you need further information please
contact your service workshop.
To perform maintenance on the
attachment
CAUTION: Working on the sweeper is often
done in dusty conditions. If you have a
gasoline operated product it is extremely
important to take care of air filter
maintenance regularly, often daily. The air
746 - 002 - 13.12.2019
3. In order to get into corners, remove the splash guard
and loosen the accessory coupling and rotate the
accessory half a turn.
4. Keep a small working angle to the surface. Too large
a working angle means the sweeper tends to move
towards you and you risk losing control of the
product.

Maintenance

WARNING: Rubbish will then be thrown
back towards the user. Use a lower
speed when reversing the product and
remember that it is easy to trip over
materials that are thrown out.
filter must be oiled to work satisfactorily.
Refer to the operator's manual of the power
unit for maintenance instructions.
WARNING: The gear housing gets hot when
the machine has been in use. To avoid
burning yourself do not touch the gear
housing.
225