Publicité
Les langues disponibles
Les langues disponibles
under voltage during maintenance or repairs, this work may only be carried out by a specialist who is familiar with the risks
involved and the relevant regulations.
• Never connect the appliance directly after transferring it from a cold to a warm room. The condensation water that forms
could destroy the appliance or result in an electric shock. Allow the device to reach room temperature before connecting it.
Wait until the condensation water has evaporated. This can take some hours.
• Do not place any naked flames such as those of burning candles on or next to the appliance.
• Do not place the appliance on soft surfaces such as carpets or beds. Do not cover the air vents of the appliance. Do not
obstruct the air circulation with objects such as magazines, table cloths or curtains. This prevents the dissipation of heat from
the appliance and can result in overheating.
• Only use the appliance in a moderate climate, not in tropical environments.
• All persons involved in operating, installing and servicing the appliance and putting it into service must be trained and
qualified accordingly and observe these operating instructions.
• Defective mains cables may only be replaced by specialists. Danger of shock hazard!
• Do not leave the packaging material lying around carelessly since it can become a source of danger for children playing with
it.
• The accident prevention regulations and the regulations of the employers' liability insurance association should be observed
at commercial institutions.
• If you are not sure about the correct connection or if questions arise which are not answered by the operating instructions,
please do not hesitate to contact support or a specialist of your choice. Consult a specialist if you are in doubt the operating
principle or the safety of the product.
PART A
1. Treble CH 1
Treble controller for channel 1 (CH 1). When turned to the left, levels are lowered, when turned to the right, they are raised.
2. Bass CH 1
Bass for channel 1 (CH 1). When turned to the left, levels are lowered, when turned to the right, they are raised.
3. Microphone Effect CH 1
Microphone effect for channel 1 (CH 1). When turned to the left, levels are lowered, when turned to the right, they are raised.
4. Volume CH 1
Volume controller for channel 1 (CH 1). Turning the knob to the right increases the volume and turning it to the left decreases it.
5. Mic/Line Switch CH 1
When using channel 1 as a microphone channel, bring the Mic/Line Switch to the down position. When using channel 1 as an
instrument channel, bring the Mic/Line Switch to the up position.
6. Input Microphone CH 1
Microphone or instrument input (XLR) for channel 1 (CH 1)
7. Treble CH 2
Treble controller for channel 2 (CH 2). When turned to the left, levels are lowered, when turned to the right, they are raised.
8. Bass CH 2
Bass for channel 2 (CH 2). When turned to the left, levels are lowered, when turned to the right, they are raised
9. Microphone Effect CH 2
Microphone effect for channel 2 (CH 2). When turned to the left, levels are lowered, when turned to the right, they are raised.
10. Volume CH 2
Volume controller for channel 2 (CH 2). Turning the knob to the right increases the volume and turning it to the left decreases it.
11. Mic/Line Switch CH 2
When using channel 2 as a microphone channel, bring the Mic/Line Switch to the down position. When using channel 2 as an
instrument channel, bring the Mic/Line Switch to the up position.
©Copyright Lotronic 2018
POWERLINE2.2
9
Publicité
