Table des Matières
Publicité
MultiFlow Quick Start
Pos : 12.23 /Tec hD OC/Sening/09-M ultiFlow/DOK-392_Kurz anl eitung F ahrer/| H12--->Vorrat-Überwac hung (opti onal) @ 3\mod_1355824879357_19.doc x @ 69144 @ @ 1
12
. Monitoring the load (optional)
Pos : 12.24 /Tec hD OC/Sening/09-M ultiFlow/DOK-392_Kurz anl eitung F ahrer/Q12 - Vorrat-Über wachung (optional) @ 3\mod_1355825067591_19.doc x @ 69673 @ @ 1
The Load management can be found in the Main Menu under Item 6 (Menu 6). It contains the
following information:
The entry field "Product Load" signifies the current remaining volume in the vehicle
compartments.
After loading set the initial value for the product.
After each discharge the uncompensated discharge volume is subtracted automatically.
The remaining Load of additive is displayed in the central display section. The additive is
intended for an additive pump controlled by the MultiFlow.
After loading set the initial value for the additive.
After each discharge the uncompensated discharge volume of the additive is subtracted
automatically.
The field "Warning at:" enables you to define a minimum Load. The additive Load is
compared with the minimum volume before each discharge.
If the level falls below the limit, a warning is displayed:
"WARNING! Additive Load almost completely used!"
This alarm is given to prevent the system from running empty which would involve a
refilling procedure.
You can deactivate the alarm by setting the minimum volume to zero.
12
Remaining volume in the
chamber
Remaining additive volume in
the storage container
Trigger alarm on undercutting
Of the selected limit
Echo of entered value
MN F09 012 US DOK-392E Issue/Rev. 2.01 (01/13)
L o a d m o n i t o r
P r o d u c t L o a d :
> 1 2 3 4 5 < ℓ
- - - - - - - - - - - - - - - - - - -
A d d i t i v e L o a d :
1 0 0 , 0 0
A l a r m a t :
ℓ
5 , 0 0
C o n f i r m w i t h P R I N T
ℓ 1 2 3 4 5
- - -
C l e a r
®
Sening
is a registered trademark of FMC Technologies
ℓ
- - -
Publicité
Chapitres
Table des Matières
