Residue Removal Via Epe2 - FMC Technologies Sening MultiFlow Manuel D'utilisation

MN F09 012 US  DOK-392E  Issue/Rev. 2.01 (01/13)

If you want to maintain these settings, continue with "Start the discharge".
Pos : 12.7 /T echD OC/Seni ng/09-MultiFl ow/D OK-392_Kurzanleitung Fahrer /| H04---> Entrestung vi a EPE2 @ 3\mod_1357904874245_19.doc x @ 71070 @ @ 1
4
.

Residue removal via EPE2

Pos : 12.8 /T echD OC/Seni ng/09-MultiFl ow/D OK-383_Betriebs anl eitung/Entres tung via EPE2 @ 3\mod_1357904906729_19.doc x @ 71116 @ @ 1

The following description is relevant only for program versions from 5.00 (approval according to
MID).
No. Name
Residue removal
8
EPE2
"Residue removal EPE2" display

The "Residue removal EPE2" menu item (menu 8)
can be used to carry out the residue removal of the
measuring system via a residue discharge pump
connected to the EPE2. For this purpose an EPE2
must be connected to the MultiFlow and configured
via the CAN bus. The "EPE2-AIII" (menu 3.1.8.5.1.4)
or „EPE2-AI" (menu 3.1.8.5.1.5) must also be active.

Residue removal is started by activating the
<START> key. Activate the <STOP> key once to
pause residue removal and once more to cancel.

If residue removal is not cancelled manually using
<STOP> it is cancelled automatically after a maximum
residue removal period defined in the "Residue
removal timeout" menu item (menu 3.1.8.5.2).
During the residue removal through "Residue removal EPE2" (Menu
8), the residue removal via "EPE2-AI" (menu 3.1.8.5.1.5) also monitors
the state of the EPE2 sensor. If a complete residue removal cycle is
detected, the EPE2 output will be disabled and residue removal will be
paused.
®
Sening is a registered trademark of FMC Technologies
Factory
Seal K
setting
F
Meaning
Control of a residue discharge pump connected to the
EPE2. For this purpose the "EPE2-AIII" or "EPE2-AI"
mode must be activated (parameter 3.1.8.5.1).
R e s i d u e r e m o v a l E P E 2
- - - - - - - - - - - - - - - - - - -
P r e s s S T A R T t o
c o n t i n u e
P r e s s S T O P t o e x i t
- - - - - - - - - - - - - - - - - - -
R e s i d u e r e m o v a l
t i m e o u t
. . . . .
9 m i n
MultiFlow  Quick Start
7