Komet MicroKom M03Speed Mode D'emploi page 13

Mounting the insert holder 1 X 38-103 mm:
• Release the holding screw 3.
• Replace the insert holder 1.
• When fitting the insert holder,
check the orientation of the
cutting edge.
J
Mounting the insert holder 1 X 38-206 mm:
• Release the holding screw 3.
• Replace the insert holder 1.
• When fitting the insert holder, check the orientation of the cutting edge.
Mounting the replaceable bridge j:
• Unscrew clamping screw k for the replaceable bridge to allow the replaceable
bridge to be removed.
• In doing so, check that the O ring l is not damaged!
5
L
4
2
1
Mounting the insert holder
4
2
6
K
3
ENgLISh
6
1
3
13