Mounting The Insert Holder - Komet MicroKom M03Speed Mode D'emploi

KOMET MicroKom® M03Speed

Mounting the insert holder

Insert holder
1
Holder
2
Holding screw
3
Holding screw
4
Differential screw
5
Adjustment scale
6
Replaceable bridge
J
Clamping screw
K
O ring
L
Mounting the insert holder 1 X 24.8-39 mm:
• Unscrew holding screw 4 to allow
the insert holder 1 to be replaced.
• Turn differential screw 5 until the
insert holder 1 can be pulled out.
• When fitting the insert holder check
the orientation of the cutting edge.
Safety notes:
• The technical notes provided in the application details depend on the environmental and application
conditions (such as machine, environmental temperature, lubrication/coolant used and desired
machining results): these are based on proper application conditions, use and compliance with the
spindle speed limits given for the tools.
• To prevent damage to machine and tool, we recommend that the drive power be calculated in
advance. The drive power which is actually available will be found in the machine manufacturer's
spindle speed/performance diagram.
• Safety equipment should be provided to protect personnel from flying chips.
• To ensure the best possible tool life, the insert should be changed promptly.
12
insert holder – holder
holder – replaceable bridge
for coarse adjustment of insert holder
high resolution gives easy read-off without vernier
for replaceable bridge
5
4
6
1