Ndustrio 191BR1G Manuel D'utilisation Et D'installation page 53

3 - Undo the screws (E) to remove the lid (F).
4 - Undo the screw (G).
5 - Position the bracket (H) so that it is touching the
microswitch (L).
6 - Tighten the screw (G).
7 - Fit the lid (F) and secure it with the screw (E).
8 - Replace the control panel (D) and the knob (B)
on completion of the operation.
9 - Raise and lower the well to check that the set-
ting is correct (the well must rest firmly on the
fixed part of the appliance).
10 - Switch on the appliance (see page 9) and
check that it operates correctly (the tempera-
ture light must be on).
ADJUSTING THE LID COUNTER-BALANCING
To carry out this operation, proceed as follows.
1 - Fit the spanner (A) onto the hexagon (B).
2 - Keep a firm grip on the spanner (A) and undo
the locking screws (C).
3 - Turn the spanner (A) clockwise to load the
spring or anti-clockwise to release it.
4 - Once the correct balance is obtained, screw in
the screws (C) without tightening them fully.
5 - Use the spanner (A) to turn the shaft until it is
located in one of the seats provided.
6 - Fully tighten the screws (C).
E
G
C C
B B
- 23 -
F
H
L
IDM-39616002400.tif
A A
IDM-39615401800.tif IDM-39615401800.tif
IT
GB
DE
FR
ES
English