Ndustrio 191BR1G Manuel D'utilisation Et D'installation page 52

ADJUSTING BURNER PRIMARY AIR (291BR1G - 291BR2G - 291BR3G)
To carry out this operation,
proceed as follows.
1 - Turn off the gas supply
tap.
2 - Remove the knob (B).
3 - Undo the screws (C)
and remove the control
panel (D).
4 - Undo the
screw (E).
5 - Set the bush (F) at the
distance as shown in
the figure.
6 - Tighten the screw (E).
After making the setting, seal the screw with
paint.
7 - Replace the control panel (D) and the knob (B)
on completion of the operation.
ADJUSTING THE WELL LIMIT STOP MICROSWITCH
Important
This adjustment must be made with the well
completely lowered.
IT
To carry out this operation, proceed as follows.
1 - Remove the knob (B).
GB
2 - Undo the screws (C) and remove the control
panel (D).
DE
FR
ES
English
locking
C
B
D
B
- 22 -
F
42±1
C
mm
C
D C
IDM-39616002100.tif
E
IDM-39616002300.tif