Alarm Setting; Alarm Handling - Velleman WS8426 Notice D'emploi

Notes:
• day language: ENG= English, ITA = Italian, FRE = French, NET = Dutch,
ESP = Spanish, DAN = Danish, GER= German
• press and hold UP [J] or DOWN [I] for fast progress
• Day of the week changes automatically depending on the set date and
time.
• the display will return to normal operation after ±7s of inactivity

Alarm setting

• Shortly press the SET button [G] to display alarm time1. The
appears.
• Press and hold SET [G] for ±2s to set the first alarm time.
• Use UP [J] or DOWN [I] to successively set the hour and minutes. Confirm
each setting with the SET button [G].
• Shortly press the SET button [G] to display alarm time2. The
appears.
• Press and hold SET [G] for ±2s to set the second alarm time.
• Use UP [J] or DOWN [I] to successively set the hour and minutes. Confirm
each setting with the SET button [G].
Remote sensor
• Slide the back of the remote sensor open (slide down) and make sure
batteries are present inside the remote sensor (see §11).
• Press the channel selector button [S3] to select the desired channel (1~3).
The channel is indicated on the LCD [S1].
Note: when multiple sensors are used they must be set to different
channels.
• Set the same channel on the base station using the CH button [J]. The
channel is shown on the LCD [E]. When multiple outdoor sensors are used,
press the CH button [J] until an arrow (
indicator [E]. The temperature of each outdoor sensor is shown
successively for ±5 seconds.
• Press the °C/°F button [S4] to set the temperature scale on the remote
LCD [S1] to °C or °F.
Note: this setting is only applicable for the temperature indication on the
remote sensor itself, not on the clock.
• Close the back of the sensor.
• The sensor can be used freestanding by unfolding the foldable stand [S6]
or hung on the wall by the suspension [S2]. Always placed the sensor in a
location protected from rain, moisture, splashing and dripping liquids.
9.
Operation
LCD brightness
• Press and hold the LCD button [H] for ±2s to set the LCD brightness.
• Use UP [J] or DOWN [I] to select the desired brightness (01~08).
• Press LCD [H] to accept the selected brightness.

Alarm handling

• Shortly press the ALARM button [K] to enable alarm 1 (
09.08.2011
WS8426
) is shown above the channel
6
icon
icon
), press again to
©Velleman nv