3.10.2 Printing The Measurement Data - SKF Maintenance Products TMEA 1P/2.5 Mode D'emploi

Note!
In case you start a new measurement, the previously stored values will
be deleted.

3.10.2 Printing the measurement data

Step 1:
Choose the measurement data to be printed: pre-alignment or post-
alignment measurement data.
Printing of the coupling and feet values before alignment:
Once the measurement is completed go to step 2.
Printing of the coupling and feet values after alignment:
After alignment, re-measure as per chapter 3.7 to 3.8 (9, 3, 12 and
then back to the 3 o'clock position) and go to step 2.
Note!
To document both pre and post-alignment measurement data:
Measure, (9, 3, 12 and then back to the 3 o'clock position) and print
the pre-alignment measurement data. Then align, re-measure and print
the post-alignment measurement data.
Step 2: Printing
Disconnect the cable from the
Stationary machine measuring
unit (marked S). Connect the
cable of the printer to the S/P
port of the display unit (fig. 29)
and to the back of the printer
(fig. 30). Switch on the printer
with the switch at the back of the
printer.
The printer performs internal
tests and initializations and when
the red indicator lights up, the
printer is ready for use.
Fig. 29. Connection of the printer
Press the print button on the display unit
TMEA 1P/2.5 / TMEA 1PEx Shaft Alignment Tools 29