Machine Configuration; Measuring Positions - SKF Maintenance Products TMEA 1P/2.5 Mode D'emploi

1.2

Machine configuration

During the alignment procedure we will refer to the part of the
machinery which will be adjusted as the "Movable machine". The other
part we will refer to as the "Stationary machine".
Fig. 3. Stationary and Movable machine
1.3

Measuring positions

To define the various measuring positions during the alignment
procedure we use the analogy of a clock as viewed from behind the
Movable machine. The position with the measuring units in an upright
position is defined as 12 o'clock while 90° left or right is defined as
9 and 3 o'clock.
Fig. 4. The analogy of a clock
A Stationary M2
B Movable M1
C Movable machine
10 Shaft Alignment Tools TMEA 1P/2.5 / TMEA 1PEx