8. OSD
Function
Quick Install
Detail Setting
Exit Menu
Quick Install
For an easy configuration of this camera the function „Quick Install" was implemented. This
function leads you through the most important camera settings, to get the best camera
parameter in a fast way at given illumination situations.
If the selected camera parameters do not show the best picture performance, the
function „Quick Install" can be performed again to change parameters.
On pressing the button „Enter" at the camera backside panel the main menu („Main Menu")
of the camera can be activated. Please use the control keys at the backside to perform the
function „Quick Install".
Main Menu
Quick Install
Detail Setting
Exit Menu
The menu „Quick Install" contains the following steps:
Quick
Install
A description of the different steps you can find in following table below.
To move to the next step inside "Quick Install" please activate the menu item "Next" in the
On-Screen-Display.
Using "Back" you move to the previous step.
Description
Fast setup of the most important parameters
Detailed setup of all camera parameters
Leave the main menu completely.
Lens
DC
Setting
Level
WD
Setting
Setting
33
WB
END