Install The Batteries - JVC LT-22HD32U Mode D'emploi

Remote Control

Install the batteries

Use batteries type UM3 (AA-Size).
Do not use old or weak batteries. The remote control may not work properly with a weak voltage from such
batteries. Replace exhausted batteries with new ones. Never try to recharge normal batteries - this could
cause an explosion.
Note:
• Exhausted batteries can leak corrosive electrolyte, which may cause damage to the remote
control - therefore remove exhausted batteries immediately.
• Batteries should not be exposed to excessive heat such as sunshine, fire or the like.
1
Open the battery
compartment.
Distance of Remote Control Operation
Maximum distance approx. 5m
The remote control handset will not work properly in the following cases:
a) If bright sunlight directly beams onto the unit front. b) If an obstacle is placed between the unit and the
c) If the batteries have not been installed according
to their polarities.
57W0151A.indb 9 57W0151A.indb 9
2
Install the batteries as shown
below, ensuring the correct
polarity.
Remote sensor
30
Transmitter window
handset.
d) If the batteries are weak.
3
Close the battery
compartment.
Point the remote control
directly at the remote sensor.
30
9
9/15/11 4:42:52 PM 9/15/11 4:42:52 PM