Manual Station search
Digital Manual Search
Channel - Digital Manual Search
Frequency(kHz)
Picture
Sound
Channel
Strength
Quality
Feature
Setup
Move
Enter
Enter
Preparation:
Select DTV in INPUT SELECT. Press MENU.
•
Select TV Connection option in Channel menu,
then press . Press ▲ or ▼ to select Antenna or
Cable, then press .
•
Select Digital Manual Search option in Channel
menu, then press .
1 Frequency of Digital channel to be searched.
2 Select Start, then press ENTER to start searching.
3 You can verify the signal strength and quality of
the selected service here. If necessary, adjust
the direction of the DVB-T antenna to obtain the
maximum signal strength.
Analogue Manual Search
Channel - Analogue Manual Search
Current Channel
Picture
Search
Fine Tune
Sound
AFC
Channel
Colour system
Sound System
Feature
Setup
Save
Move
Enter
Enter
Preparation:
Select TV in INPUT SELECT. Press MENU. Select
Analogue Manual Search option in Channel menu,
then press .
1 Press , then press ▲ or ▼ to select the current
channel, then press ENTER.
2 Frequency of current selected Analogue channel.
3 Press , then press
search from current selected Analogue channel's
frequency position.
4 Already correctly and optimally installed. Do not
change anything here. Any changes can cause
picture or sound disruption. The video can also be
affected.
5 Press , then press ▲ or ▼ to select AFC On or
Off, then press ENTER.
6 Colour system has already been preset to Auto.
Do not change anything here. Any changes can
cause picture or sound disruption.
7 The correct sound system is already installed. Any
changes can cause sound disruption.
8 Finally, press red button to save the searched
channel.
57W0151A.indb 13
57W0151A.indb 13
Channel selection
With the numbered buttons.
Example:
•
474000
•
•
Press P + or – to change up or down a channel. This
Start
takes approx. 2 seconds. If the auto search only stored 5
stations, only these 5 will appear. Skipped channels will
not appear (see P.12).
Channel List
Return
Exit
Return
Menu
The channel List shows a list for each receivable
programmes for TV/DTV and Radio.
Press CH LIST to display the Channel List.
Press
Press CH LIST to display the selected channel.
Information display
Press . The program information will appear for approx. 4
seconds.
•
The following figure is an example of DVB-channel
reception.
001
217.25 MHz
ENTER
ENTER
On
Auto
BG
1 Channel Name
2 Program Title
Return
Exit
Return
Menu
3 Next program detail and current program detail
4 Program Duration
5 Current time
6 There are two or more audio languages. (see below)
7 Radio icon will appear in case of Radio channel.
8 There is one or more subtitle languages. (see below)
9 DVB Teletext available
or
to perform intermittent
0 Signal strength and quality
! Frequency and Bit Rate of channel
@ Program Detail
Audio/Subtitle language for DVB-channel
If the current watching DVB-channel has more than one
audio language or subtitle language, you can change
them with AUDIO I/II or
•
•
•
Note:
•
•
Basic Operation
No. 2: Press 2.
No. 29: Press 2 and within 2 seconds, press 9.
No. 929: Press 9, 2, 9 same as above.
or
to select the desired channel.
twice, more information and signal
If you press
strength and quality will appear. (DVB-T)
0672 PQR
672_PQR_SMPTE Color Bar_0101_0000_0001
672_PQR_SMPTE Color
Bar_0101_0000_0001_Audio3_ABCDEFGHIJKLMNOPQRSTUVWXYZabcdefg
hijklmnopqrstuvwxyz
Frequency : 842000 kHz
Bit Rate : 5196000 bps
Strength :
Quality :
alternate by / buttons
.
Press AUDIO I/II. Audio language menu will appear.
Then press ▲ or ▼ to select the Audio language.
You can also select the audio format (Stereo, Left or
Right) by pressing of
or .
Press
, then press
or
to select DTV Subtitle.
Then press ▲ or ▼ to select the Subtitle language. Then
press ENTER.
Some DVB-broadcasts may not provide subtitle
language service.
To cancel the Audio/Subtitle language menu, press
RETURN.
13:00
13:00-13:01
I/II
Stereo
24%
79%
13
9/15/11 4:43:06 PM
9/15/11 4:43:06 PM