Programming - Lupine BLIKA Manuel D'utilisation

Programming

Programming:
For this purpose, simply press and hold the lampheads button until it turns blue, red or green as shown
in the table on the right side. If the finger is removed from the button, the mode is selected.
Example:
To get into 4-step mode, hold the button until the blue LED flashed 4 times, then release the button.
Adjusting the brightness of the lower button LEDs:
The brightness of the spot, diffuse, red and green light can be adjusted in 5 steps through the
lower button.
Press and hold the
Switch on the
wanted LED lower button
24 Blika
The Output is Release as soon as
the desired level is
increased in 5
reached
steps
Press the top button Available adjustments
until it lights
1x red Release the button, SOS activated
1x blue
2 - step
2x blue
3 - step
3x blue
3 - step
4x blue 4 - step
5x blue
3 - step
Red
1x red
2x red Green
3x red Spot
4x red Diffus
5x red Start with highest beam (Default) / lowest beam
6x red
Early "battery low warning" (Default)
7x red Late "battery low warning"
8x red Alpine SOS / SOS (Default)
9x red Doubleclick on / off (Default)
10x red Stealth on / off (Default)
11x red
The LEDs of the lower button get cut in the top button /
The LEDs of both buttons work independently (Default)
12x red Reset
Default setting
on / off
on / off
on / off
on / off
Blika 25