H.Koenig G2 Manuel D'utilisation page 6

2. If the filter is incorrectly placed, the LED will not lit on and there will be no steam even if
you press the steam button.
Steam Ironing :
1. Fill the tank with tap water as indicated above. For better results, let the filter rest for a few
minutes in a bowl of water.
2. Turn on the appliance, the tank LED will lit on.
3. Use the temperature wheel to choose the correct setting. The temperature LED will lit on
and turn back off when the chosen temperature has been reached. The iron is then ready to
use. The temperature LED will turn on and off during usage, this only ensures the chosen
temperature is maintained at all times. Before usage, let the iron warm up for 3 minutes).
4. Before usage, clean the iron following the below instructions:
Press the steam button for 20 seconds, let it rest for 30 seconds and repeat twice. When the
temperature LED is off, the appliance is ready for usage.
5. After usage, place the iron on its rest pad, set the temperature wheel to "MIN" and turn off
the unit.
6. Remove the water tank and empty it.
Note : It is normal to hear a vibration sound when the steaming starts, this only means there
was air in the filter. Once that air evacuated, the sound will stop.
Dry ironing :
1. Turn on the appliance, the tank LED will lit.
2. Use the temperature wheel to choose the correct setting. The temperature LED will lit on
and turn back off when the chosen temperature has been reached. The iron is then ready to
use. The temperature LED will turn on and off during usage, this only ensures the chosen
temperature is maintained at all times. Before usage, let the iron warm up for 3 minutes).
3. After usage, place the iron on its rest pad, set the temperature wheel to "MIN" and turn off
the unit.
Note : When you change the temperature setting, wait for a few minutes before resuming
ironing to avoid damaging your clothes. Wait for the temperature LED to turn off before
continuing.
Vertical steam ironing :
Follow the same instructions as for normal steam ironing then place the
iron on vertical position within 5 to 15cm of the clothes you wish to iron.
(Fig.6)
This function allows you to iron vertically suspended clothes or curtains.
Never direct the steam to a person or an animal.
Note :
1. Do not fold the supply cable.
2. During vertical ironing, maintain a 90 degree angle and do not use for longer than 2 min at
a time to avoid water leaking.
AUTOLOCKING FUNCTION OF THE STEAM BUTTON
If you need to iron for a long period of time, you can lock the steam button by pressing it backwards.
This will allow a constant steam supply. If you wish to unlock the steam button, you just need to push it
forward.
Note : Please be extremely careful when you have the steam button on a locked position. If you run
out of water, the water tank alarm will go off, you can then unlock the steam button in order to go
ahead and fill in the tank.