Stopping A Cycle - SciCan STATCLAVE G4 Manuel De L'utilisateur

9. Remove the load
Open the door. Remove the trays or pouch racks using
the tray extractor provided with the unit.
CAUTION! The metal parts will be hot.
6.2

Stopping a Cycle

CAUTION!
If the screen displays a CYCLE FAULT code or a NOT STERILE message, the contents are not sterile. See Section
11 Troubleshooting for more information.
If the wraps on the wrapped instruments are not dry when the load is removed, the instruments must be handled in
an aseptic manner for immediate use or re-sterilized.
To stop a cycle BEFORE sterilization is complete, press the
STOP icon at the bottom right of the touchscreen:
1. If you stop the cycle before sterilization is complete,
the unit will remind you that the load is NOT STERILE.
Press the STOP icon to continue.
2.
To stop a cycle DURING the drying phase, press the STOP
icon at the bottom right of the touchscreen:
1. If you stop the load during the drying phase, the unit
will remind you to CHECK FOR DRYNESS.
Press the STOP icon to continue.
2.
30