Operation Of Magneto Fit Mf 400 - Davita Magneto FIT MF 300 Mode D'emploi

NIGHT: By pushing the button all displays will be cleared. Only the small LED in the frequency display is shining. The
function of the unit will be unaffected. By pressing any button the displays will be switched on again.
Storage of the operation parameters:
By pushing the ON/OFF-button the frequency will be stored. If the unit will be switched on again these parameters
will be imported and the unit works with these parameters. So it is possible to switch on the unit with an usual clock
timer and the unit starts with the stored parameter.

Operation of Magneto Fit MF 400

ON/OFF: By pushing the button the unit can be switched on or off. After switching on the unit the ON/OFF-LED
begins to shine.
ERROR: This LED shines, if the mat is not or not correct connected with the control unit. The unit can not be used.
FREQUENCY: By pushing the „+" button the frequency can be increased up to 19 Hertz.
By pressing the „–" button the frequency can be decreased until 0 Hertz. If 0 Hertz is reached the control unit is
deactivated.
FREQUENZROTATION: If the "+" button will be pushed a little longer at 19 hertz the frequency rotation function will
be activated. Here the single frequencies are rotating active for 5 seconds. Many users like this function very much.
By pushing the "-" button this modus ca be left.
ACTIVE: If the control unit is operating, the LEDs of the display will be powered one after another (Running light).
The speed of the running light is independent from the adjustment of the frequency.
TIMER: If the frequency is adjusted higher than 4 hertz the timer switches on and the LED begins to shine. The Timer
will be on for 30 minutes. After this time the units switch off. The frequency will be adjusted to 0 Hertz.
INTERVAL: By pushing the button the LED will be activated. There is a change in the function of the unit. The
control unit will be switched on for 6 seconds and after that switched off for 3 seconds (Rest) After that the process
starts again. By pressing the button again the function can be deleted. Some scientists have the opinion, that the
body can assimilate the energy of the magnetic fields so optimal.
PULSE: By pushing the "+" or "-" button the intensity will be increased or decreased. Here exists the possibility to
variate the magnetic active time between 15% and 90%. The application time can be considerably shortened. Every
illuminated line in the LED means an increase of 15%.
NIGHT: By pushing the button all displays will be cleared. Only the small LED in the frequency display is shining.
Circuit points: Wall power supply, Magnetic field therapy mat
- 9 -