Electrolux ESF5206LOW Notice D'utilisation page 16

Masquer les pouces Voir aussi pour ESF5206LOW:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

16
www.electrolux.com
Problem and alarm code
The programme does not start.
The appliance does not fill with wa‐
ter.
• The end indicator flashes 1 time
intermittently.
• The Start indicator flashes con‐
tinuously.
The appliance does not drain the
water.
• The end indicator flashes 2 times
intermittently.
• The Start indicator flashes con‐
tinuously.
The anti-flood device is on.
• The end indicator flashes 3 times
intermittently.
• The Start indicator flashes con‐
tinuously.
The appliance stops and starts
more times during operation.
The program lasts too long.
Small leak from the appliance door.
The appliance door is difficult to
close.
Rattling/knocking sounds from in‐
side the appliance.
Possible cause and solution
• Make sure that the appliance door is closed.
• Press Start.
• If the delay start is set, cancel the setting or
wait for the end of the countdown.
• The appliance has started the procedure to
recharge the resin inside the water softener.
The duration of the procedure is approxi‐
mately 5 minutes.
• Make sure that the water tap is open.
• Make sure that the pressure of the water
supply is not too low. For this information,
contact your local water authority.
• Make sure that the water tap is not clogged.
• Make sure that the filter in the inlet hose is
not clogged.
• Make sure that the inlet hose has no kinks
or bends.
• Make sure that the sink spigot is not clog‐
ged.
• Make sure that the drain hose has no kinks
or bends.
• Close the water tap and contact an Author‐
ised Service Centre.
• It is normal. It provides optimal cleaning re‐
sults and energy savings.
• If the delayed start option is set, cancel the
delay setting or wait for the end of the
countdown.
• The appliance is not levelled. Loosen or
tighten the adjustable feet (if applicable).
• The appliance door is not centred on the
tub. Adjust the rear foot (if applicable).
• The appliance is not levelled. Loosen or
tighten the adjustable feet (if applicable).
• Parts of the tableware are protruding from
the baskets.
• The tableware is not properly arranged in
the baskets. Refer to basket loading leaflet.
• Make sure that the spray arms can rotate
freely.

Publicité

Table des Matières
loading

Table des Matières