Indicators On The Charging Station And Troubleshooting; Indicators On The Robot Lawn Mower And Troubleshooting - EINHELL GC-RM 500 Instructions D'origine

11. Indicators on the charging station and troubleshooting

LED indicator (21)
Off
Lit up green
Flashing green
Lit up red

12. Indicators on the robot lawn mower and troubleshooting

The alarm LED (53) is lit up red
Fault
"Robot lawn mower
has lifted".
"Robot lawn mower
is stuck"
The robot lawn
mower has come
to a stop near an
obstacle.
Anl_GC_RM_500_SPK9.indb 40 Anl_GC_RM_500_SPK9.indb 40
GB
Description
- No power supply
- Ready for mowing
- Rechargeable battery (22) is
fully charged
- Perimeter wire (18) is cor-
rectly installed
- Perimeter wire (18) is se-
vered
- Perimeter wire (18) is not
properly connected
- Rechargeable battery (22) is
charging
Possible cause
- The lifting sensor has been
continually tripped for 10 se-
conds
- The obstruction sensor has
tripped 10 times within one
minute
- 40 -
Solution
- Check the power supply
- Inspect the perimeter wire (18) for a break
- Check the two connections on the char-
ging station (19)
- Wait until the rechargeable battery (22) is
fully charged.
Remedy
Press the "OK" button (61) to restart the ro-
bot lawn mower.
- If this fault occurs frequently, check the
mowing area for obstacles taller than 10
cm and either remove them or cordon
them off from the mowing area with peri-
meter wire (18).
Press the "OK" button (61) to restart the ro-
bot lawn mower.
- Check whether the robot lawn mower
is blocked by an obstacle or jammed
between trees, bushes, etc. Remove the
obstacle or avoid this area.
- If this fault occurs frequently, check the
way in which the perimeter wire (18) has
been laid. Pay particular attention to tight
angles, corridors, fences, rocks, etc., and
adjust the layout of the perimeter wire (18)
if necessary.
- Check whether the grass is too tall and
the robot lawn mower gets blocked. If this
is the case, mow the grass to below 60
mm.
14.11.2019 10:53:22 14.11.2019 10:53:22