La Sommeliere TR3V180 Notice D'utilisation page 13

The controls of your Wine cooler (the Lower zone)
RUN
DISPLAY
•
"UP" Button
Used to raise(warm) the temperature in 1 .
•
"DOWN" Button
Used to lower(cool) the temperature in 1 .
•
"DISPLAY"
To shows the temperature of the lower compartment.
Setting the Temperature Control
•
To set the temperature:
Connect the power cord to a properly grounded outlet. In the event of a power interruption, all
previous temperature settings are automatically erased and it will default to a preset temperature
setting of: 12℃.
Set the desired cooling temperature by pressing the buttons adjacent to the "UP/DOWN"
program. Each depression of the buttons will scroll through the available temperature settings in
increments of 1 degree. The temperature selected will flash in the LED display for approximately 5
seconds, then revert back to display the temperature of the internal cabinet
The temperature setting can be adjusted from 12
Shelves
•
To prevent damaging the door gasket, make sure to have the door all the way opened when
pulling shelves out of the rail compartment.
•
For easy access to the storage content, you must pull the shelves approximately 1/2 out of the rail
compartment, however this unit was designed with a plastic post on each sides of the shelf tracks
to prevent bottles from falling.
.
•
When removing the shelf out of the inner rail, make sure to remove all items first. Then move the
shelf to the position where the notch of shelf is exactly under the plastic post and lift the shelf. In
order to replace the shelf, repeat steps described above in reverse.
Note
•
If the unit is unplugged, power lost, or turned off, you must wait 3 to 5 minutes before restarting
the unit. If you attempt to restart before this time delay, the Wine Cooler will not start.
•
When you use the wine cooler for the first time or restart the wine cooler after having been shut
C
UP
DOWN
to 18
13