Pressure Testing; Pressure Test Method - Fulgor Milano F4PGK305S1 Instructions D'installation

Masquer les pouces Voir aussi pour F4PGK305S1:

Table des Matières

Les langues disponibles

Pressure Testing

The appliance must be isolated from the gas supply piping

system by closing its individual manual shut-off valve during

any pressure testing of the gas supply piping system at test

pressures equal to or less than 1/2 PSIG (3.5 kPa).

This appliance, as well as its individual shut-off valve, must

be disconnected from the gas supply piping system during

any pressure testing of the system at test pressures in excess

of 1/2 PSIG (3.5 kPa).

When checking appliance regulator function, make certain

pressure of natural gas supply is between 6 and 14 inches

of water column or, if converted for LP gas, between 11 and

14 inches.

THE PRESSURE TESTING SHOULD BE PERFORMED BY

MEANS OF THE INJECTOR THREAD ZONE

Gas test inlet

Thread Pressure

• Remove grate and burner cap

• Remove aluminum gas spreader

• Temporarily remove the injectors

• Connect the pressure Test instrument into injector holder

thread zone (M6x0,75)

• Check if the cooktop has the correct pressure

• Fix the injector removed for testing and replace the parts

in the right position.

Table des Matières

Table des Matières

F6pgk305s1 F4pgk365s1 F6pgk365s1