Fulgor Milano F4PGK305S1 Instructions D'installation page 12

EN
Step 3
Insert the cooktop centered into the cutout opening.
Make sure the front edge of the counter top is parallel to
the cooktop. Make final check that all required clearances
are met.
8
Step 4
Four clamp brackets are provided with your unit.
After cooktop has been installed into the countertop, install
the brackets on the burner box as shown in figure.
Install the clamp brackets on the front and back of the
burner box bottom (if the cabinet construction does not
provide clearance for installing brackets at the burner box
front back install the clamp brackets on the lateral position
of burner box).
step A place the clamping screws into brackets
step B attach brackets by using the attachment screws on the
selected location of burner box, tighten screws just enough
to hold brackets in place.
step C position brackets so that they are with the clamp
screw in contact with the counter top bottom
step D tighten attachment screws securely.
step E check that the front edge of the cooktop is parallel to
the front edge of the countertop tighten the screw clamping
against the countertop.
DO NOT OVER TIGHTEN