Precautions For Use; Before Each Use; Technical Details - MSW UR-2 Manuel D'utilisation

PRECAUTIONS FOR USE

Before use please read the manual instruction carefully!
Before each use, all parts should be checked if they are no damaged, missing or worn in a way that prevents proper
operation.
If the device has been overloaded or subjected to a shock impacts, it must be checked by an authorised service technician
before being used again.
It is forbidden to use the device if it is damaged or worn, or if it is not functioning normally. Contact the authorised
service for inspection and repair.
The device should be checked regularly by the authorised service centre.
Use only spare parts recommended by the manufacturer.
WARNINGS!
All screw connections of the device must be checked regularly. Also the screw connections in the device's fixing should be
checked if they are properly tightened.
It is forbidden to walk or stand under the hanging load (it is also forbidden to walk or stand in the immediate vicinity of
the load).
It is forbidden to overload (weight greater than its maximum permissible load) the device.
Always pay close attention to the load and the lifting device.
It is forbidden to lift people or animals with the device.
It is forbidden to lift loads with the device over people or animals.
It is forbidden to leave suspended loads unattended.

BEFORE EACH USE

Read all the instructions and safety instructions.
It should be always checked that the load is securely and correctly attached.
Avoid situations when the load could oscillate.
Unauthorized persons should be warned when the load is going to be moved, also unauthorized persons should be at a
safe distance from suspended loads.
Avoid situations in which the device is exposed to moisture and dirt.
The device should be checked regularly and any worn or damaged parts should be replaced immediately by authorised
service.
Failure to follow directions and safety instructions could result in serious personal injury or
death!

TECHNICAL DETAILS

Angle α:
Model
MSW-UR-2 MSW-UR-4
α=0°
α=30°
1 2
α=45°
1,05 2,11
α=60°
1,11 2,22
α=90°
1,18 2,35
α=120°
1,43 2,86
α=135°
2 4
α=150°
2,5 5
α=180°
4 8
0 0
MAXIMUM DIAMETER OF THE ROPE
5 mm 8 mm
6
MSW-UR-10
MAX LOAD [T]
5
5,26
5,56
5,88
7,14
10
12,5
20
0
12 mm
α=0°
Snatch block load factor
Angle rope [α]
α=30°
2,0
α=45°
1,9
α=60°
1,8
α=90°
1,7
α=120°
1,4
α=135°
1,0
α=150°
0,8
α=180°
0,5
0 (without load)
MSW-UR-2
MSW-UR-10 6093
MSW-UR-4
7