Cameo ZENIT W600 SMD Manuel D'utilisation page 21

Dimmer = Dimmer curve
Curve
Power = Operating mode
Mode
Dimmer = Dimmer response
response
Color Ca- = Color calibration
libration
Autolock = Automatic locking of
the controls
PWM = LED PWM frequency 800 Hz / 1200
Frequ-
ency
Fan = Adjust fan control
Linear Light intensity increases linearly with
DMX value
Exponential Light intensity can be finely adjusted at
lower DMX values and broadly adjusted at
higher DMX values
Logarithmic Light intensity can be broadly adjusted at
lower DMX values and finely adjusted at
higher DMX values
S-curve Light intensity can be finely adjusted at
lower and higher DMX values and broadly
adjusted at medium DMX values
Normal Constant brightness
Boost Brief maximum brightness (Blinder func-
tion, approx. 3 seconds)
LED Light responds abruptly to changes in
DMX value
Halogen Light behaves like a halogen spotlight
with slight brightness changes
RAW R, G, B and W with maximum value 255
User Calibra- Individual color calibration. Cross-mode
tion brightness setting of R, G, B, A and L with
values from 000 - 255.
Factory Cali- Factory calibration of R, G, B and W
bration (across all modes)
Smart Calibra- Merging factory and RAW calibration
tion
On Automatic locking of the controls after
approximately 1 minute of inactivity.
After attempted input the display shows:
"Locked!"
Unlock: press and hold UP and DOWN
simultaneously for approx. 5 seconds
Off Automatic locking of the controls is
disabled
Configuration of LED PWM frequency
Hz / 2000 Hz /
3600 Hz / 12
kHz / 25 kHz
Auto Fan Automatic fan speed control
Silent Fan Constant fan speed with adjusted bright-
ness
Off Disabled fans at adjusted brightness
21