Grohe SENSIA IGS Notice De Montage page 28

MOUNTING INSTRUCTIONS
Commissioning
26
1
27
1 2
Navigation
28
Use the following icons
on the remote control to
navigate :
COMMISSIONING
15 – 25 °fH
Test water hardness with
strip and select value.
Back Continue
54
2
3
Commissioning programme
29
Selecting a language
1
Select the language you
COMMISSIONING
want by pressing "Language"
several times.
English
Confirm by pressing
Press icon and
"Continue".
select language.
Press "Continue".
Measuring the water hardness
2
Measure the water hardness where
COMMISSIONING
the unit is installed using the test strip
provided.
15 – 25 °fH
Compare the colour of the test strip with
Test water hardness with the chart below.
strip and select value.
Water hardness measured
Select the water hardness you have measured by pressing the "Water
hardness" icon several times. You can select from the following ranges :
< 15 °fH, 15 – 25 °fH, 25 – 35 °fH, > 35 °fH
3
Confirm by pressing "Continue".
COMMISSIONING
Fitting the nozzle
Remove cap and then
assemble the nozzle.
The spray arm is extended. Remove
the cap and fit the nozzle until it clicks.
Press "Continue".
4
Commissioning complete
Commissioning is complete.
COMMISSIONING
Commissioning Press "Continue".
complete. Press
"Continue" to exit.
The start display appears.
Thank you for
choosing GROHE.
1 sec.
Setting on unit
< 15 °fH
< 15 °fH
15 – 25 °fH
25 – 35 °fH
> 35 °fH
> 35 °fH
55