Initial Operation; Changing The Battery - Soehnle CHEST BELT CONNECT 100 HR Mode D'emploi

4. Initial operation

1. Undo the hook (D) from the loop on the chest belt (4.1).
2. Put the chest belt on and fasten the hook back up.
Position the transmission module (A) below the chest muscles
for men or below the bosom for women (4.2). The belt should be
fastened firmly around the rib cage and the sensor areas (B) should
have good contact with the skin. Wear the tracker directly against
your skin, otherwise no measurement is possible.
Make sure that the belt is not too loose or too tight and is placed
the right way round. For this purpose you will find marks for left and
right on the inside of the transmission module. Adjust the belt length
to your chest size if necessary.
3. Lift the transmission module and moisten the sensor areas slightly
(4.3).
4. Shortly after both sensor areas come into contact with the skin, the
transmission module automatically starts to send the pulse data via
Bluetooth to the app connected.
®
5. Press the button on the app to connect the chest belt. Your current
pulse rate is now displayed on the app.

5. Changing the battery

1. Open the battery compartment on the back of the transmission
module (5.1).
2. Replace the weak battery with a new one.
ATTENTION! Insert the battery correctly. Bear in mind the polarity. Only
insert type CR2032 lithium batteries.
3. Screw the cover back onto the battery compartment.
ATTENTION! When closing the battery compartment, make sure that
the washer sits correctly, otherwise moisture can penetrate and the
device can be damaged.
EN