ero electronic LDS Manuel De Service page 82

DEFAULT CONFIGURATION DEFAULT CONFIGURATION DEFAULT CONFIGURATION DEFAULT CONFIGURATION DEFAULT CONFIGURATION
PARAMETERS PARAMETERS PARAMETERS PARAMETERS PARAMETERS
The configuration parameters can be loaded with
predetermined default values. These data are the
typical values loaded in the instrument prior to
shipment from factory. To load the default values
proceed as follows:
a ) The internal switch (V2, see fig. 9) should be
open.
b) The upper display will show:
LMS - LHS LDS
C n F C n F
C n F C n F C n F
C n F C n F
C n F C n F C n F
c) Push the pushbutton; the lower display will
show the firmware version.
C n F C n F
C n F C n F C n F
A. 0 1 A. 0 1 A. 0 1 A. 0 1 A. 0 1
A. 0 1 A. 0 1
A. 0 1 A. 0 1 A. 0 1
d) Mantaining the pressure on the pushbutton
push the pushbutton also.
The instrument will show
O F F O F F O F F O F F O F F d.F F d.F F
d.F F d.F F d.F F
d F L d F L d F L d F L d F L
e ) Press pushbutton to select between table 1
(european) or table 2 (american) default
parameter set. The display will show:
LXS-A-0F.pmd 2
t b. 1 t b. 1 t b. 1 t b. 1
t b. 1 t b. 1 t b. 1 t b. 1 t b. 1 t b. 1
d F L d F L
d F L d F L d F L
f) Press FUNC pushbutton; the display will show:
L. d t. L. d t. L. d t. L. d t. L. d t. L. d t. L. d t. L. d t. L. d t. L. d t.
This means that the loading procedure has been
initiated. After about 3 seconds the loading
procedure is terminated and the instrument
reverts to visualization as in point b).
A. 2
19/01/2004, 11.29