Configuration Procedure - ero electronic LDS Manuel De Service

4) If, during configuration procedure, a readout in
°F has been selected, it is necessary to put on the
front of the instrument, the additional label,
located at the INDEX page, in order to cover the
°C indication.
°F °F °F °F °F
5) Re-insert the instrument.
6) Switch the instrument "ON".
The display will show COnF.
NOTE NOTE : If "CAL" indication is displayed, press NOTE NOTE NOTE
immediately the pushbutton to return to
the configuration procedure.
7) Push the FN pushbutton.
Models LMS and LHS show, on the lower
display the parameter code and on the upper
display the actual parameter value.
Model LDS shows the parameter code and
its value alternately on the display.
GENERAL NOTES for configuration. GENERAL NOTES for configuration. GENERAL NOTES for configuration. GENERAL NOTES for configuration. GENERAL NOTES for configuration.
FN = This will memorize the new value of
the selected parameter and go to the
next parameter (increasing order).
ST = This will scroll back the parameters
without memorization of the new value.
= This will increase the value of the
selected parameter
= This will decrease the value of the
selected parameter.
lxs-1-0f.pmd 6
CONFIGURATION CONFIGURATION CONFIGURATION CONFIGURATION CONFIGURATION PROCEDURE PROCEDURE PROCEDURE PROCEDURE PROCEDURE
P1 - Input type and standard range P1 - Input type and standard range
P1 - Input type and standard range P1 - Input type and standard range P1 - Input type and standard range
0 = TC type L range
1 = TC type J range
2 = TC type K range
3 = TC type N range
4 = RTD type Pt 100 range
5 = RTD type Pt 100 range
6 = TCtype T range
8 = TC type L range
9 = TC type J range
10 = TC type K range
11 = TC type N range
12 = RTD type Pt 100 range
13 = TC type T range
NOTE NOTE NOTE: setting a readout with °F as engineering NOTE NOTE
unit it is necessary to put on the front of the
instrument, the additional label located in the
"INDEX" of this manual.
P2 = Initial scale value P2 = Initial scale value P2 = Initial scale value P2 = Initial scale value P2 = Initial scale value
Not present when P1 = 5
Insert the initial and full scale values which are
going to be used by the PID algorithm to calculate
the input span.
P3 = Full scale value P3 = Full scale value P3 = Full scale value P3 = Full scale value P3 = Full scale value
Not present when P1 = 5
Insert the initial and full scale values which are
going to be used by the PID algorithm to calculate
the input span.
NOTES: NOTES NOTES NOTES NOTES
1) the minimum input span (P3 - P2) is 300 °C or
600 °F for TC input and 100 °C or 200 °F for
RTD input.
2) Changing P2 and/or P3 parameters, the rL
and rH parameters will be realligned to it.
GB GB GB GB GB 6
16/01/2004, 9.29
0 / +800 °C
0 / +800 °C
0 / +999 °C
0 / +999 °C
-199 / +500 °C
-19.9 /+99.9 °C
0 / +400 °C
0 / +999 °F
0 / +999 °F
0 / +999 °F
0 / +999 °F
-199 / +999 °F
0 / +752 °F