Sony HT-K25 Mode D'emploi page 12

7: Attaching the jack cover and stand
(continued)
Using the control center laid
flat
Place the control center flat on a level
surface.
Note
Do not apply downward force to the control center
with the display window facing down. Doing so may
cause scratched or damage to the control center.
Using the control center in
the upright position
Make sure you attach the supplied stand.
To stand the control center on its
side
1
Attach the stand to the screw hole on
the side of the control center using the
supplied screw.
2
Place the control center on the stand.
GB
12
To stand the control center on its
rear
1
Attach the stand to the jack cover using
the supplied screw.
2
Place the control center upright on the
stand.
Notes
• Use the supplied stand only when you use the
control center in an upright position. Do not attach
the stand when you use the control center laid flat.
• To move the control center, hold the control center
itself. If you hold the stand, it may break.
• Do not use the control center in an upright position
without attaching the stand. If you do not attach the
stand, the control center will be unstable and may
fall over.